H3C Technologies H3C SecBlade SSL VPN Cards - Manual (Page 16)

9
Configuring Interfaces
Select the Interface Management tab to enter the interface management page shown in Figure 6 . Select
an interface, and then click Configure to enter the interface configuration page.
Figure 6
The following table describes the interface configuration item:
Item Action
Configure IP address of
interface
Required
Specify the address assign mode, IP address, and subnet mask for the selected
interface.
NOTE:
•
Interface management supports configuring only physical Ethernet interfaces. Logical interfaces are not
supported.
• If you select None as the address assign mode, after you apply the configuration, the system will delete
all IP address configurations or DHCP or BOOTP configurations of the current interface.
Configuring a Log Host
Select the Loghost tab to enter the log host configuration page shown in Figure 7 . Click Add to configure
a log host for the device.
Figure 7 Log host page
The following table describes the log host configuration items:
Item Action
Logging Host IP Address
Required
Specify the IP address of the log host. System logs will be sent to this log host.