Downloading the patch package to mpus – H3C Technologies H3C S10500 Series Switches User Manual
Page 5
4
The output shows that the patch has been uninstalled successful.
Downloading the patch package to MPUs
NOTE:
Download the patch package to the flash memory of the active MPU and the standby MPU. Skip this
section if the patch package is already located there.
You can download the patch package through FTP or TFTP. The device can act as the FTP server, FTP
client, or TFTP client. The following describes how to download the package when the switch serves as
the FTP server.
•
Configure the FTP server on the switch
# Enable the FTP server on the switch.
[Sysname] ftp server enable
# Create a local user account abc and specify the password as pwd.
[Sysname] local-user abc
[Sysname-luser-abc] password simple pwd
# Specify the service type as FTP.
[Sysname-luser-abc] service-type ftp
# Specify the user level as 3 so that users using this account can upload the patch package to the server.
[Sysname-luser-abc] authorization-attribute level 3
[Sysname-luser-abc] quit
•
Upload the patch package from the PC to the FTP server
# Log in to the FTP server.
c:\> ftp 1.1.1.1
Connected to 1.1.1.1.
220 FTP service ready.
User(1.1.1.1:(none)):abc
331 Password required for abc.
Password:
230 User logged in.
# Specify the file transfer mode as binary.
ftp> binary
200 Type set to I.
# Put the patch package (S10500-CMW520-R1126H03.bin in this example) to the root directory of the
flash of the active MPU on the switch.
ftp> put s10500-cmw520-r1126h03.bin
200 Port command okay.
150 Opening BINARY mode data connection for /s10500-cmw520-r1126h03.bin.
226 Transfer complete.
ftp: 463364 bytes sent in 2.23 secs (207.32 Kbytes/sec).
# Copy the patch package on the active MPU to the root directory of the flash on the standby MPU.
Copy flash:/s10500-cmw520-r1126h03.bin to slot1#flash:/s10500-cmw520-r1126h03.bin?
[Y/N]:y