H3C Technologies H3C S12500 Series Switches - Manual (Page 17)

14
Connecting an AC power cord
CAUTION:
Typically 10 A busbars are available in the equipment room but the LSTM2PEMC6 requires a 16 A power
cord (AC), so you need to use a 16 A busbar, and make sure that the AC power module system can
provide enough power. For AC power cords used in different countries or regions, see H3C S12500
Routing Switch Series Installation Guide.
To connect AC power cords:
1. Remove the strain-relief screws of the power cord retention clip, and remove the retention clip.
2. Insert the connector of the AC power cord into the PEM receptacle.
3. Install the retention clip to the connector and fasten the screws to lock the power connector.
4. Connect the other end of the AC power cord to the power source.
Figure 20 Connecting the AC power cord