Ensemble Designs BrightEye 55 Genlockable Sync Generator and Test Signal Generator User Manual
Page 9
TM
BrightEye 55
BrightEye 55 - Page 9
OPERATION
Control and operation of the BrightEye 55 is performed from the front panel and
with the BrightEye Control application.
Some control settings and parameter choices are only available with BrightEye PC or
Mac. These parameters cannot be monitored from the front panel.
Front Panel Controls and Indicators
The front panel shown in the figure below provides status indicators and control
over video and audio output.
Status Indicators
The following status indicators are provided on the front panel:
Std (Standard)
The currently selected output standard (
NTSC or PAL) will illuminate green.
Ref (Reference)
The status indicator will be green when a valid reference is present and locked.
Video
The currently selected video pattern
Black (choices include Black, Flat 20%,
Flat 80%), Bars (choices include 75% Bars, 100% Bars, SMPTE Bars), Safe
(
Safe Title), Sweep (choices include Sweep, Mono Sweep, MultiBurst,
Mono Burst), or User (chosen in BrightEye PC or Mac) will illuminate green.
Selection of these different choices can be made from the front panel and in
BrightEye PC or Mac as explained next in the
Controls section of this manual.
Slate
Illuminates green when the signal identification slate is enabled. To change the
Slate text ID, use the
Config menu in the BrightEye Control application.
Tone
Illuminates green when analog audio tone is enabled.
BrightEye 55 Front Panel
NOTE
: