Ensemble Designs BrightEye 55 Genlockable Sync Generator and Test Signal Generator User Manual

Page 11

BrightEye 55

BrightEye 55 - Page 11

Video
This control selects the video test pattern with the following choices:

• Black choices:,

Black, Flat 20%, or Flat 80%.

• Bar choices: 75% Bars, 100% Bars, or SMPTE Bars.
• Sweep choices: Sweep, Mono Sweep, Multi Burst, or Mono Burst.
• User choices – This pattern can be specified in the Test Pattern menu,

providing over eight additional patterns (

Pathological, Pulse and Bar,

Ramp, Digital Blanking, Analog Blanking, Interlace, Crosshatch,

and

Unit Circle).

Mono Sweep and Mono Burst are recommended for analog applications and Sweep
and Multi Burst for SDI video applications.

Slate
This control allows the identification slate on the test signal output to be turned
on and off. The content of the slate can be configured in the

Config menu in the

BrightEye Control application.

Tone
This control toggles the analog audio tone on and off. This applies to the analog
audio out, the AES out, and the embedded tone on the SDI out. Advanced
configuration of digital and analog audio reference levels is available in the

Config menu in the BrightEye Control application.

HD Sync
This control selects the HD Tri Level Sync standard. Select 1080i, 720p, 1080p, or
1080sF. This output also follows the output

Standard selected, either 525 or 625.

For more information, see the

FUNCTIONAL DESCRIPTION section at the

beginning of this manual.

NOTE