Ensemble Designs 5130 Digital to Analog Composite Converter with Digital DA - Manual (Page 4)

Model 5130 Reclocking Serial DA with Composite Monitor Outputs
5130-4
INSTALLATION
Plug the 5130 module into any one of the slots in the 1 RU or 3 RU frame and install the
plastic overlay provided onto the corresponding group of rear BNC connectors associated
with the module location. Note that the plastic overlay has an optional adhesive backing
for securing it to the frame. Use of the adhesive backing is only necessary if you would
like the location to be permanent and is not recommended if you need to change module
locations. This module may be hot-swapped (inserted or removed) without powering down
or disturbing performance of the other modules in the system.
CABLING
Refer to the 3 RU and 1 RU backplane diagrams of the module below for cabling instruc-
tions. Note that unless stated otherwise, the 1 RU cabling explanations are identical to
those given in the 3 RU diagram.
3 RU Backplane
1 RU Backplane
Connect the serial
digital input video signal
to be distributed into the
Serial In BNC.
Connect composite
output destinations to
the Monitor Out 1-4
BNCs.
Connect serial digital
output destinations to
the Serial Out 1-4
BNCs.