Eneo IRLED-401E - Manual (Page 18)

18
Mounting to a camera housing
• Install the illuminator in a properly airy zone.
• To make the nuts positioning inside the external slide easier, we recom-
mend loosening the housing fastening screws, and sliding it on the
external slide ⓒ while keeping it hanging on the slide.
• Place the illuminator bracket ⓐ in the desired position, under the exter-
nal slide ⓒ or, where possible, under the housing basis.
• To make this operation easier, it is possible to loosen the knurled hand-
wheel ⓑ or in case the nut opposite to the handwheel, and rotate the
bracket as to the illuminator.
• Mount the illuminator to the external slide ⓒ in a firm way, or where
possible, at the housing basis.
• Place back and close the housing body, direct the illuminator in the
desired position, and fasten the whole.
• If loosened during the bracket installation, please remember to tighten
the knurled handwheel ⓑ and/or the nut opposite to the handwheel.
B
A
C