Eneo IRLED-401E - Manual (Page 13)

13
DE
EN
FR
PL
RU
Notes on safety
Please also pay attention to the enclosed safety instructions, and carefully
read through this instruction guide before initial operation.
Important points of advice are marked with a caution symbol.
Warnings
• The product must only be installed and used by qualified technicians, in
compliance with statutory regulations of the place where the product is
used.
• Before starting any installation or maintenance operations, activate all
safety cut-outs on the main supply with a contact breaker gap of at
least 3 mm.
• If properly installed, the illuminator is completely maintenance free.
• For a correct installation, it is not necessary to open the device.
• Do not try to open or repair the product; in case of need, contact after-
sales service.
• In case of opening or tampering of the device, warranty conditions will
be lost.
• The device gives out infrared radiation through LED; the use of controls,
regulations or proceedings, which are different from those stated in this
manual, can cause dangerous exposures to infrared radiation.
• To clean plastic parts, use only water.