Eneo IRLED-401E - Manual (Page 16)

16
Wall mounting
Remove the cover protective film after the unit installation.
• Install the illuminator in a properly airy zone.
• In case of pole mounting, use a pole mount adapter.
• Place the bracket ⓐ in the desired position against the wall.
• To make this operation easier, it is possible to loosen the knurled hand-
wheel ⓑ or in case the nut opposite to the handwheel, and rotate the
bracket ⓐ as to the illuminator.
• Mark the position of mounting holes.
• Make the mounting holes, taking into consideration the type of material,
which the wall is made of, and the type of fixings to be used.
• Mount the bracket ⓐ to the wall in a firm way.
• If loosened during the bracket installation, please remember to tighten
the knurled handwheel ⓑ and/or the nut opposite to the handwheel.
B
A
60
122.5
28 44
6,5 6,5