Eneo VHM/KV2 - Manual (Page 8)

left right
A
B
C
S H
F
g
3.1.1 Configuration of the factory-installed 24V heating for 12V operation
Voltage Solder bridges A Solder bridges B Solder bridges C
24V (factory) A open on both sides
(right/left) B closed on both sides
(right/left) C open on both sides
(right/left)
12V configuration A closed on both sides
(right/left) B open on both sides
(right/left) C closed on both sides
(right/left)
3.2 Assembling the 230V heater kit VHM/H220
(Art. No. 71301)
F The heater is screwed directly into the front section F of the housing. Then, remove the front
section from the housing by loosening the two 4mm Allen wrench screws.
H,g The heating element H is attached at the designated place using 3x6mm self-tapping
crosshead screws g.
S A duct S is provided inside the housing profile for running the connection cable to the screw
terminal.