beautypg.com

Mounting instructions, Safety instructions, Specifications – Eneo VHM/KV2 User Manual

Page 6

background image

Type

VHM/H24W

VHM-H220

VHM/KV1

VHM/KVS2

VHM/KV2

Art. No.

71602

71301

79609

79612

79627

Input voltage 12VDC / 24VAC

110-265VAC

24VAC

230VAC

24VAC

Description

24V resistance

heater on circuit

board for in-

stallation in the

VHM-EC/ST

housing series

230V PTC
heater for

installation

in the VHM-EC/

ST housings

Cable connec-

tion

distribution

board for

VHM-Z series

Cable connection

distribution board for VHM-

EC/ST series

Enclosed

2 screws, 2 separating bolts

flexible and heat-resistant

connection cable

2x screws, 2x washers

Power
consumption

Approx. 6W

Approx. 7W

Mounting Instructions

Heaters and cable connection distribution board

for VHM-EC/ST housing and VHM-Z housing

2. Safety Instructions

The following instructions are for your own safety and must be followed.

• Before putting the individual components into operation, please read the safety instructions and

the following assembly instructions.
• Keep the assembly instructions safe for use at a later date.
• Screw terminals are only intended for permanent connection to the power supply network.
• When using flexible connecting cables, connector sleeves must be used.
• The earth wire connection must be wired leading, attention should be paid to the correct allocation

of L1 and N.
• When laying the cable make sure that it is not stressed, bent or damaged and that no moisture can

permeate it.
• An easily accessible, all-pole circuit breaker with a minimum contact gap distance of 3mm should

be installed close to the device in order to be able to freely switch the device on and off during

service work. The earth wire must have a low impedance in compliance with DIN VDE 0100.
• The connection work must only be carried out by a qualified electrician in compliance with VBG 4.

1. Specifications

This manual is related to the following products: