Eneo VHM/KV2 - Manual (Page 7)

A
S H
F
r
f
r
3. Heaters
3.1 Assembling the VHM/H24W heating kit
F, A Front panel, Middle Unscrew the front section F (with the glass pane) off the middle section
section of housing of the housing A.
H Heater circuit Screw the heater circuit board H onto the front section F.
board The resistances must display on glass insert.
f, r Screws, Use the screws f and the separating bolts r (8mm) from the enclosed
separating bolts package according to the diagram.
S Cable duct Bring the heater circuit board’s power connection through the cable duct
S to the connection circuit board on the back of the housing and connect.