Eneo VKCD-1416C - Manual (Page 35)

10
2.4 HEATER KIT INSTALLATION (option)
1. Place the Heater element in slot "A". Please ensure that the cables are facing
upwards and the heater is pointing towards the Dome.
2. Place the PCB in slot "B". Please ensure that the PCB is facing inside of the Dome
with the connection blocks at the top.
3. Place the plug in the Socket "C" (J508) which is found on the controller board.
• HEATER (IF APPLICABLE)
Power Supply 24VAC
Power Consumption 20W
Heater ON at 25
°C (±5°C)
Heater OFF at 35
°C (±5°C)
• POWER
Use Certified/Listed Class 2 power supply transformer only.