Eneo HDC-2080Z03 - Manual (Page 9)

8
MAIN Default Descriptions
SCENE
ENHANCE
NORMAL
NORMAL – Optimized for the normal indoor and outdoor in the good
lighting condition.
WDR – Improves the visibility for the high bright area and the dark area
by the double captures of image with LONG and SHORT exposures.
With WDR ON, the frame rate becomes half by the double captures.
WDR level can be selected from LOW, MID and HIGH.
Care should be taken to select this mode because video may lose its
quality in some environments by the over compensation.
D-WDR – Improves the visibility by compensating the video gain for the
dark area. Noise can increase in the dark area accordingly.
BLC – Improves the visibility for the dark object by the bright back light.
Outside area of BLC window can over saturate.
BLC has a target window for compensation and its size and position
can be set by H-POS, V-POS, H-SIZE and V-SIZE.
HLC – Cuts out the highlight area with black mask and excludes it from
compensation. Lower HLC LEVEL cut out video from the lower level.
3D-NR MID
3D-NR is a very sophisticated and powerful time-based noise reduction
technology by monitoring the noise for the several video frames and defining
and eliminating them consecutively at low light.
Higher setting reduces noise much more but results in losing the sharpness
and the tail effect or the motion blur for the fast moving target at low light.
DAY/NIGHT EXT
Sets DAY / NIGHT to EXT, AUTO, COLOR and B/W.
SMART IR can be set to reduce the saturation by the strong IR illumination
in the night in any menu of EXT, AUTO and B/W(NIGHT)
Setting SMART IR in any menu is identically applied to other menu.
Zero(0) turns off SMART IR and High setting avoids the saturation strongly
but the corners will be darker accordingly.
IR LED Control(AUTO/OFF) is available with IR LED model only.
If IR LED is set to OFF, IR LED will be turned OFF but DAY or NIGHT is still
determined by the built-in light photo sensor.
EXT – DAY or NIGHT is determined by the built-in light photo sensor.
Camera with IR LED must be set to EXT.
AUTO – Used when DAY or NIGHT is determined by light level through
the lens and DAY from/to NIGHT is switched automatically by the
scene brightness.
D<-->N THRESHOLD, D<->N GAP, D<->N DELY and SMART IR can be
set in the menu.
When EXPOSURE>AGC is less than 12, DAY/NIGHT AUTO is disabled
and forcibly switches to ___(DAY) to avoid the malfunction.
EXT, B/W(NIGHT) and COLOR(DAY) is independent on AGC level.
When EXTERNAL IR LED is used with NON IR LED model, please set
to IR LED MODE ON.
B/W(NIGHT) – Forcibly removes IR cut filter and switches to B/W
regardless of light level.
COLOR(DAY) – Forcibly DAY/NIGHT is disabled and outputs color video.
PICT
ADJUST
Sets WHITE BAL, SHARPNESS, COLOR GAIN, GAMMA,
See ‘6.5 PICT ADJUST’ for detail.
SPECIAL
Sets CAM TITLE, MOTION, PRIVACY, LANGUAGE, PIXEL COMP,
TV SYSTEM. See ‘6.6 SPECIAL’ for detail.
SYSTEM
Sets TV SYSTEM, RESOLUTION, COMM.SETUP, LANGUAGE and
FACTORY DEFAULT.
EXIT
SAVE & EXIT – Exits the menu after saving the parameters.
EXIT – Exits the menu without saving the menu.