Eneo HDC-2080Z03 - Manual (Page 7)

6
5. Installation and commissioning Instructions
•
Make sure the power is removed before the installation.
• Follow the order for applying power.
First connect the low voltage (DC12V or AC24V), then plug the AC adapter to AC outlets to avoid an
improper reset from power jitter and a damage from the surge voltage when no load.
5.1. Installation
The camera has a 1/4” thread insert on its top and bottom side for mounting the camera to a tripod or
the wall or ceiling with a corresponding mount.
5.2. Power Supply Connections
Camera can work with either 24VAC or 12VDC, dual voltage power. It does NOT require the polarity-
matched connection for 12VDC supply. Primary and secondary grounds are completely isolated to avoid
the possible ground-loop problems. Its excellently wide operating voltage range of 10.5V-30V for DC and
12-28.8V for AC gives an extra flexibility at the installation.
6. Setup Menu
6.1 In the menu
Setup menu can be accessed and controlled by OSD control joy stick at the back of camera.
Five commands are available with the joy stick.
Picture of OSD may differ by the models.
Joy stick
SYMBOL descriptions for joystick operation;
-▲,▼,◀,▶
denotes the directions of Joystick
lever operation.
- ☟ denotes the long press down straightly
for about 1.5 seconds.
Zoom & Focus Adjustment
(Only works when OSD Menu is not operating)
▲ Zoom In
▼ Zoom Out
◀
Focus Near
▶
Focus Far