beautypg.com

Eneo HDC-2080Z03 User Manual

Page 10

background image

9

6.3 ZOOM/FOCUS

ZOOM /

FOCUS

Default

Descriptions

FOCUS

MODE

ZOOM

PUSH

ZOOM PUSH, AUTO and MANUAL modes are available for focusing.

ZOOM PUSH

– Focusing is activated only when zoom in/out is working.

AUTO – Focusing is working always.

MANUAL – Focusing can only be adjusted by ▲,▼ of OSD control

joystick or the remote control via RS-485.

D-ZOOM

OFF

D-ZOOM(Digital zoom) is available up to 32x.

D-ZOOM starts working when the optical zoom reaches its maximum tele-

position. Zoom ratio is displayed on the right bottom corner of the monitor if

SPECIAL>DISPLAY>ZOOM RATIO is set to ON.

LENS

REFRESH

OFF

LENS REFRESH can be set to 1~10day and performs the scheduled LENS

Initialization automatically. Every initialization occurs when the time reaches

the scheduled time after setup or power up.

When LENS REFRESH initiates LENS Initialization, a notification ‘LENS

INITIALIZING…’ appears on the top left corner on the monitor.

LENS INIT

ON

Lens initialization is necessary during the installation or the regular

operation to align the position data with the mechanical positions whose

lens elements may move and deviate from its calibrated position by the

shock or vibration, for example, during the transportation.

LENS INIT starts the lens initialization when pressing the joystick lever

straight down for about 1.5sec.

LENS INIT checks the positions for zoom and focus at both of the end

positions and saves them for the references.

Lens initialization is automatically executed at power up.

CAUTION

It is strongly necessary to execute LENS INIT in cases below;

1) At the final step for the installation.

2) When focus becomes out of control by the shock or vibration

.

ZOOM / FOCUS

FOCUS MODE ZOOM PUSH

D-ZOOM OFF

LENS REFRESH OFF

LENS INIT.

ON

RETURN

RET