Eneo PXD-2080Z03 D - Manual (Page 12)

• Extreme care should be taken NOT to scratch the bubble dome surface while
the camera installing or adjusting.
• Care should be taken the cable is NOT to be damaged, kinked or exposed in
the hazardous area.
• Tighten enough the dome cover fixing screws so that there should be NO
gap between Lens hood and clear bubble to avoid the light inflow from IR LEDs.
Limit of pan & tilt
1) Pan limit:
Pan is limited to +/- 173°. Do NOT force to rotate the gimbal over the limit to
prevent from the internal damage.
2) Tilt limit:
Tilt is limited to 25° min ~ 90° max. with reference to the ceiling when the
inclination of camera module is 0°, that is, the image is aligned horizontally.
3) Inclination limit (Horizontal image alignment):
Inclination limited to +/-50° max.
Installation Instructions
12
NETWORK AF ZOOM CAMERA
CAUTION
25
º
90
º
CAUTION : Tilt may NOT reach 25° min. if some IR light reflects to the lens
when the inclination is NOT 0°. When Tilt is set to near the minimum limit,
examine and verify that NO IR refection occurs.