Eneo PXD-2080Z03 D - Manual (Page 10)

Installation Instructions
10
NETWORK AF ZOOM CAMERA
Assembly Screw
(4x12mm)
Mounting Screw
(4x30mm)
1. Locate the mounting template at the installation position and drill the ceiling
or wall if needed.
2. Open the dome cover by loosening screws(4x12mm). Use the torque wrench
supplied.
3. Connect the dome cable with the power source cable.
4. Set the camera’s viewing angle.
5. Put the dome cover to the dome base unit and tighten the assembly screws.
- Place the dome base unit on pre-drilled position and fix it through using mounting
screws (4x30mm).
- Route the Ethernet & Power cable to the connecting place.
Torque
Wrench
• Surface mount
• Pole mount adaptor
• Tilted mount
• Wall mount
(Requires additional
Surface mount)
• Tilted junction mount
■ Optional Mounting Accessories