Archgard 27-DVIE22N - Manual (Page 9)

27-DVIE22
9
MINIMUM FIREPLACE OPENING DIMENSIONS
J K L M N
DIMENSIONS
“Controls Out” 17-3/4”
(451 mm)
15”
(381 mm)
16”
(406 mm)
25 1/2”
(648 mm)
0”
DIMENSIONS
“Controls In”
17-3/4”
(451 mm)
15 1/2”
(381mm)
16”
(406 mm)
30”
(762 mm)
3”
(76mm)
Masonry Fireplace
A T T E N T I O N
This fireplace has been designed to be installed into a Masonry or Factory Build Wood Burning Fireplaces
ONLY. Never attempt to install the appliance into a combustible enclosure.
If the information in these instructions are not followed exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
J
SIDE VIEW
Min flue size required
4” (102) x 7” (178)
Fig. 9-A
TOP VIEW
L
M
K
N
Fig. 9-B
Secure the flexible liner at the top of the fireplace and at the termination. DO
NOT use silicone as this will void the flame sensor warranty. Use mil-pac or
other non silicone sealant and three (3) screws or gear clamps to seal the
liner at each end.
Mil-pac
Mil-pac
SEALING THE VENT
Roof Termination
Fig. 9-C
Fig. 9-D
Screws or
gear clamp
Screws or
gear clamp
DO NOT USE SILICONE TO SEAL VENT