Archgard 27-DVIE22N - Manual (Page 8)

27-DVIE22
8
The control panels can be mounted in the following different ways. They are shipped in the “Controls In” configuration. They can be
moved to the “Controls Out” configuration by removing the two mounting screw on each side and swinging the panels out and re-
installing the screws. They can also be disconnected and placed remotely within the limits of the gas connections and electrical wiring
making sure to place them away from any heat source over 150 degrees Fahrenheit or 65 degrees Celsius
Main On/Off switch must be connected to the surround switch or jumpered and in the “on” position for
the remote to operate the fireplace
27-DVIE22
Use Shallow Trim
Use Deep Trim
CONFIGURE THE FIREPLACE - CONTROL PANEL LOCATIONS
LEFT
RIGHT
FRONT
FRONT
FRONT
Fig. 8-A
Fig. 8-B
Fig. 8-C
Fig. 8-D
Fig. 8-E
Fig. 8-F