AML ACC-7037 4-Position Battery Charger - Manual (Page 2)

© 2013 AML
2190 Regal Parkway • Euless, TX 76040
800.648.4452 • Local: 817.571.9015
© 2013 AML
2190 Regal Parkway • Euless, TX 76040
800.648.4452 • Local: 817.571.9015
LED Color Description
Off No power supplied to charger.
Green If no battery is present in the charger, green indicates that
there is power available. If a battery is present in the charging,
position, green indicates that the battery is fully charged.
Red Battery is present in the charger and the battery is
being charged.
Symptom
LED does not light when
the terminal charger is
powered on.
LED stays green when
the battery is inserted.
LED stays red for more
than 4 hours.
Cause
Charger is not receiving
power.
Battery is not seated
firmly in the battery
charger, or the battery is
not properly installed in
the charger.
Battery is charged.
Battery faulty and can
not be charged.
Suggested Action
Make sure the power
supply is securely
connected and receiving
power.
Make sure the battery is
properly seated. Second,
test battery in an approved
AML terminal/handheld.
Battery may be defective.
Normal status.
Replace battery with an
AML approved battery.
Introduction
The ACC-7037 4-Position Battery Charger charges up to four Li-Ion
batteries. This allows batteries to be quickly changed at the end or
beginning of work-shifts, assuring the user a freshly charged battery.
The charging time for a fully depleted battery pack is approximately
2 hours.
About This Guide
This guide provides instruction on setting up and using the ACC-7037
4-Position Battery Charger.
Set Up
Setting up the charger includes unpacking, connecting the power
cable, and placing the charger on a tabletop.
Unpacking the Charger
The shipping box includes the following:
·
One ACC-7037 4-Position Battery Charger
· One PWR-7160 Power Supply
· One 120 VAC Power Cable (or country specific)
· This User’s Guide.
If any parts are missing or damaged, contact your authorized
Customer Support Representative immediately. Save the shipping
box for storing or shipping.
Connecting the Power
The PWR-7160 power supply is included with the ACC-7037 4-Position
Battery Charger. If a country-specific AC power supply is required,
please contact your authorized Customer Support Representative.
Use only an American Microsystems, Ltd. approved power supply;
output rated 12 VDC and a minimum of 5 Amps. The power supply
connects to the ACC-7037 by a 2.1mm x 5.5mm barrel connector,
center positive.
To connect power to the charger:
1. Connect one end of the Power Supply Cable to the Power
Connector on the side of the charger.
2. Connect the other end of the Power Supply AC to a
standard electrical outlet.
3. The indicator LEDs should turn GREEN to indicate that
power is available.
Charging
Turn OFF the terminal or handheld computer when removing
the battery. Place the battery with metal contacts facing
downward into an open charging position. The battery
begins to charge as soon as it is inserted.
Indicator Lights
Troubleshooting