All Power APW5118 - Manual (Page 10)

9
Owner’s Manual
Operating Instructions
Start-up Procedure
1. Make sure water supply is connected and turned on.
2. Release gun safety if locked.
3. To allow air to escape from the hose, squeeze trigger on the gun until there is a
steady flow of water coming out from the nozzle.
Starting Engine
1. Check oil and gas.
2. Connect hose and turn on water.
3. Squeeze trigger.
4. Make sure the engine switch is on the ON position (illustration 1).
5. Set the fuel valve to open (illustration 2).
6. Set choke to CLOSE position (illustration 3) & set throttle to slow (illustration 4).
7. When starting engine, pull cord slowly until resistence is felt, then pull rapidly.
8. If engines starts and fails to continue running or if increase resistance is felt during
starting pull attemps repeat step 3 - 7.
4) Throttle Control
1) ON/OFF Switch 2) Fuel Valve
3) Choke