Step 7: finishing up, Installation – Extron electronic AVTrac 42-122-xx User Manual
Page 18
Installation
AVTrac • Installation
16
Step 7: Finishing Up
At this point, the track and connectivity box must be secured to the floor, the electrical power must be connected, and
the AAP sockets must be populated.
To complete the installation of the AVTrac, follow these instructions:
7-1
Lay the cables and power cords flat against the base
track. If necessary, feed excess cable back into the
wall.
7-2
Snap the cover track onto the base track.
Ensure cables lay flat
Fit cover track
7-3
Before cutting and gluing carpet, remove all dust
and debris with a vacuum cleaner.
Cut the carpet or carpet tiles so that they run up
to but do not cover the aluminum track (see the
diagram below).
Cut carpet
Carpet covers ramps
but not track.
N
Cut the carpet to abut the edge of the cover
track. Do not align the cuts to the edge of
the ramps as this will leave a gap between
the end of the carpet and the cover track.
- MVX Plus 128 VGA A (2 pages)
- SY DVIAM-RGBHVF (2 pages)
- CCR 204 (1 page)
- N9700/6 (1 page)
- IP Link IR Learner IPL T IRL (1 page)
- Scalable Multi-Graphic Videowall Processors MGP 464W Series (2 pages)
- Computer-Video Interface RGB 558 AKM (2 pages)
- IPL T S2 (45 pages)
- Computer-Video Interface RGB 508 AKM (4 pages)
- GLI 2000 2BNC (2 pages)
- RGB 109xi (2 pages)
- DAS101CM-4 (1 page)
- Surface Mount Boxes SMB 102 (2 pages)
- CVEQ1 (2 pages)
- Wall and Floor Box Mountable Interfaces RGB 468xi (36 pages)
- Ethernet Control Interface IPL T PCS4 (2 pages)
- RCAF-BNCM/50 (1 page)
- IP Link Accessory Power over Ethernet Inserter IPA T IPA (1 page)
- CVEQ1 Series (3 pages)
- DVI Interface DVI-RGB 150 (2 pages)
- ASA 100 Series (3 pages)
- SVF-2BNCF PM/10 (1 page)
- IPL T S Series (79 pages)
- Hideaway HSA 200S Series (3 pages)
- CPM208 (1 page)
- 488-01 (1 page)
- 800 (2 pages)
- RGB 164xi (1 page)
- Extension Kits AVTrac 4R (2 pages)
- Control Panel CTL208CM (12 pages)
- Dual Window Multi-Graphic Processor MGP 462D (2 pages)
- Architectural Interface RGB 440 (2 pages)
- Extron IPL T SFI244 (6 pages)
- Network Device HSA 222 (4 pages)
- IR Repeater IRL 20 (1 page)
- Control Modules ACM (1 page)
- DVI 201 A D (2 pages)
- Network Device HSA 222S (2 pages)
- Low Profile Floor-Mount Raceway System for A/V Connectivity AVTrac (24 pages)
- IPL T S6 (2 pages)
- Interface IPL T PC1 (2 pages)
- Video Sync Separator VSS 100 (1 page)
- PoleVault System A/V Source Inputs (4 pages)
- Sync Converter/Stabilizer SCS 300 (1 page)