Step 2: wall, Installation – Extron electronic AVTrac 42-122-xx User Manual
Page 10
Installation
AVTrac • Installation
8
Step 2: Wall
Cut cable access hole in wall
2-2
Using a drill, box cutters and/or a saw, cut a 4" W x
1½" H (10.2 cm x 3.8 cm) hole at the base of the wall.
If there is a metal base stud, use a hand saw or tin
snips to cut it at both edges of the hole and bend
it back into the hole so that the stud lies flat on the
floor. (Use a file to remove any jagged edges that
might damage cables.)
The hole will eventually be covered by the
baseboard, so it does not have to be perfect.
4" (10.2 cm
)
1½" (3.8 cm)
Mark wall
2-1
If necessary, remove the baseboard from the bottom
of the wall and mark where the AVTrac will abut the
wall.
This manual shows an AVTrac installation with cables being run inside a drywall cavity. If the cables from the AVTrac
system will not be run inside a drywall cavity, ignore this section and go to Step 3 (Track) on the next page.
To run cables from the AVTrac system inside a drywall cavity, follow these instructions:
- MVX Plus 128 VGA A (2 pages)
- SY DVIAM-RGBHVF (2 pages)
- CCR 204 (1 page)
- N9700/6 (1 page)
- IP Link IR Learner IPL T IRL (1 page)
- Scalable Multi-Graphic Videowall Processors MGP 464W Series (2 pages)
- Computer-Video Interface RGB 558 AKM (2 pages)
- IPL T S2 (45 pages)
- Computer-Video Interface RGB 508 AKM (4 pages)
- GLI 2000 2BNC (2 pages)
- RGB 109xi (2 pages)
- DAS101CM-4 (1 page)
- Surface Mount Boxes SMB 102 (2 pages)
- CVEQ1 (2 pages)
- Wall and Floor Box Mountable Interfaces RGB 468xi (36 pages)
- Ethernet Control Interface IPL T PCS4 (2 pages)
- RCAF-BNCM/50 (1 page)
- IP Link Accessory Power over Ethernet Inserter IPA T IPA (1 page)
- CVEQ1 Series (3 pages)
- DVI Interface DVI-RGB 150 (2 pages)
- ASA 100 Series (3 pages)
- SVF-2BNCF PM/10 (1 page)
- IPL T S Series (79 pages)
- Hideaway HSA 200S Series (3 pages)
- CPM208 (1 page)
- 488-01 (1 page)
- 800 (2 pages)
- RGB 164xi (1 page)
- Extension Kits AVTrac 4R (2 pages)
- Control Panel CTL208CM (12 pages)
- Dual Window Multi-Graphic Processor MGP 462D (2 pages)
- Architectural Interface RGB 440 (2 pages)
- Extron IPL T SFI244 (6 pages)
- Network Device HSA 222 (4 pages)
- IR Repeater IRL 20 (1 page)
- Control Modules ACM (1 page)
- DVI 201 A D (2 pages)
- Network Device HSA 222S (2 pages)
- Low Profile Floor-Mount Raceway System for A/V Connectivity AVTrac (24 pages)
- IPL T S6 (2 pages)
- Interface IPL T PC1 (2 pages)
- Video Sync Separator VSS 100 (1 page)
- PoleVault System A/V Source Inputs (4 pages)
- Sync Converter/Stabilizer SCS 300 (1 page)