AEC Colortronic Granulator - M103 - Manual (Page 13)

3-3 Accessing the Cutting Chamber
You will need to access the cutting chamber before initial startup and for various
maintenance procedures.
Use the following procedure to access the cutting chamber:
1. Turn the main power off, remove the line fuses, and tag the machine as out of
service.
2. Open the toggle fasteners.
3. Remove the discharge box.
4. Open the cutting chamber door.
5. Carefully remove the screen.
3-4 Closing the Cutting Chamber
After completing any maintenance or adjustments inside the cutting chamber, use the
following procedure to close the cutting chamber and resume use of the granulator:
1. Carefully install the screen.
2. Close the cutting chamber door.
3. Replace the discharge box.
4. Close the toggle fasteners.
5. Replace line fuses, turn power on, and remove the out of service tag from the
machine.
4 Inch Granulator Chapter 3: Installation 13 of 47