ACTi MNR-310 - Manual (Page 33)

www.acti.com
MNR-310 System Administrator ’s Manual
33
Connect the Devices
Follow the procedures to connect the devices. These devices are supposed to be connected in
the sequence shown below.
Step Description
 Connect the monitor to MNR.
(Local display can support up to 2 different ports at the same time: HDMI + VGA)

Connect the USB keyboard and mouse to MNR

Finish setting up your eSATA storage device if needed (e.g. RAID configuration for
multiple disks), connect it to MNR and power it on. MNR will recognize it as a normal
single hard disk.

Connect the network switch to MNR via one of the LAN ports

Plug the power adapter into MNR and electricity outlet. If your MNR ’s set up includes
a power ignition control module, refer to POWER IGNITION CONTROL MODULE
INSTALLATION for proper installation.

Connect MNR to the Internet if remote management via the Internet is required
6
Tip
MNR supports iSCSI NAS. For detailed information on how to use iSCSI NAS with MNR, please
refer to our article introducing
Using iSCSI NAS with NVR .
1 2
3
4
5
Internet