Tcd-2100 hardware manual – ACTi TCD-2100 User Manual

Page 8

TCD-2100 Hardware Manual

4) Power LED

The LED will light up after device has successfully completed the boot process

5) Serial Port LED

LED will light up when serial port is active

6) Power Input

Connect the power adaptor here if your power input is DC12V.

7) Reset Button

Step 1:

Switch off IP device by disconnecting the power cable

Step 2:

Press and continue to hold the Reset Button (with a sharp tipped object, like a pen.)

Step 3:

Reconnect the power cable while continuing to hold the reset button.

The red

Power LED light will flash on for 3 second first, turn off for about 15 seconds, flash on for

another second and turn off again. By this time the reset to default operation is already

completed.

This will take around 20 seconds from power up.

You may then release the

reset button. This length of time fluctuates slightly with the environment. The Power LED light

will come back on and stay on after a few more seconds. The unit will start up with factory

default settings automatically.

PIN

NAME

DESCRIPTION

12V

DC Power Input

GND

Ground Pin