ACTi TCD-2100 - Manual (Page 16)

www.acti.com
TCD-2100 Hardware Manual
16
Manually adjust the IP addresses of multiple devices
If there are more than one device to be used in the same local area network and there is no
DHCP server to assign unique IP addresses to each of them, all of the devices would then
have the initial IP address of 192.168.0.100 , which is not a proper situation for network
devices – all the IP addresses have to be different from each other. The easiest way to assign
devices the IP addresses is by using IP Utility :
With the procedure shown above, all the devices will have unique IP addresses, starting from
192.168.0.101. In case there are 20 devices selected, the last one of the devices would have
the IP 192.168.0.120.
Later, by pressing the “Refresh” button of the IP Utility, you will be able to see the list of devices
with their new IP addresses.
Please note that it is also possible to change the IP addresses manually by using the Web
browser. In such case, please plug in only one device at a time, and change its IP address by
using the Web browser before plugging in the next one. This way, the Web browser will not be
confused about two devices having the same IP address at the same time.