ACTi TCD-2100 - Manual (Page 12)

www.acti.com
TCD-2100 Hardware Manual
12
Via RS-232 Connection
Terminal Block Wire Mapping
Pin Number / Label IP Device Pin Camera Pin
1 TX + TX + RX
2 TX -
3 RX+ RX + TX
4 Rx-
NOTE: The pins/cables of the analog camera may be labeled differently depending on
the location or country where the camera is purchased. For example, some devices may
have TX - pin labeled as "A” or “485 -”, etc. Refer to the camera documentation or
contact the manufacturer to verify the corresponding pin labels and ensure proper wiring
connection.
CAUTION: Incorrect wiring may cause damage to the connected devices.
DISCLAIMER: ACTi will not be responsible for any damage caused by improper wiring.
3. Connect a ground wire to one of the GND terminal pins of the IP device (via Power or DI/P
terminals) to complete the connection.