ACTi KCM-5211E - Manual (Page 15)

www.acti.com
Hardware Manual
15
Other Connections
This section describes the procedures in preparing the external devices that you can connect
to the camera. The camera supports DC12V power input, Digital Input and Output (DI/DO),
Audio Input and Output devices, as well as Serial Devices like a Pan-Tilt (PT) Scanner using
the bundled terminal blocks. The use of these devices, however, is optional.
Connecting a Power Adaptor (Optional)
In case of using a non-PoE switch or your PoE switch has limited power supply, you can
purchase a power adaptor and directly connect the camera to a power outlet. The power
adaptor must be connected to the supplied terminal block before use.
To do this, follow the procedures below:
1. Loosen the screws of the 12V and GND pins of the power terminal block.
2. Take note that a standard power adaptor cable has two (2) different wires:
White stripe: Connects to 12V Pin
Connects to GND Pin