ZeeVee ZyPer4K (10G-IP) - Manual (Page 12)

Page 12
|
ZyPer4K Configuration Guide www.zeevee.com
Using the Tabs in ZyPer4K Management Software
Video Genlocked tab
The Video Genlocked tab allows you to switch video between sources and displays without any video processing and
frame buffering. When switching between sources, the display loses video/sync momentarily.
Display Wall tab (default tab)
In the Display Wall tab you can:
• Switch sources with video buffering so there is no loss of video at the display.
• Create a video wall, which allows you to take a single source and split it across multiple displays, such as a 2x2 wall.
To set up a video wall:
1. Set Wall parameters in the Wall Settings properties area. For Wall Size, enter number of displays in configuration
(columns x rows). For Bezel, adjust the bezel options to match the bezel width (in pixels) of the actual displays to
ensure the video is displayed properly across all screens. The maximum wall size configuration is 5x5.
2. Drag a display icon into each open slot (to create the video wall) in the Video Wall section. Ensure that all display
icons have been positioned correctly (display names such as Top Left, Top Right, and so on will help ensure this).
3. Drag the source video icon you want to display into the Wall Group icon.
Note – You can still drag individual sources to individual displays in this mode.
Drag a display icon into
each Wall open slot to
create the Video Wall. 2x2 Video Wall shown
after all 4 slots have
been filled.