Westermo LRW-102 - Manual (Page 18)

18 6650-2260
Configuration
All needed configurations and parameter settings are done by the DIP-switches, located
under the top lid of the LRW-102 (LRW-102PP).
!
DIP-switch settings
Before DIP-switch settings:
Prevent damage to internal electronics from electrostatic discharges (ESD) by
discharging your body to a grounding point (e.g. use of wrist strap)
Note: Disconnect power before DIP-switch settings.
S2 S1
S1 DIP-switch
ON
1 2 3 4 5 6 7 8
Not used
S2 DIP-switch
Factory settings
ON
1 2 3 4 5 6 7 8
Set status output at local
or remote error
ON
1 2 3 4 5 6 7 8
S1
ON
1 2 3 4 5 6 7 8
Set status interface
at local fibre link error
(Not used in pp version)
ON
1 2 3 4 5 6 7 8
Multidrop end unit
(use chanal 1 for end unit,
not used in pp version)
ON
1 2 3 4 5 6 7 8
Multidrop unit, mid unit
(Not used in pp version)
ON
1 2 3 4 5 6 7 8
S2
ON
1 2 3 4 5 6 7 8
Redundant ring
(Not used in pp version)