Westermo IDW-90 - Manual (Page 28)

28 6620-2200
&D – DTR Control
Syntax:
AT&D
Parameters:
0:
The DTR signal is ignored (Default)
2: Upon DTR switch from ON to OFF, the call is hang up.
DTR need to be high to accept incoming calls. (Default)
4: Upon DTR switch from ON to OFF, the call is hang up DTR doesn’t affect
incoming calls accepted .
**dabort – Dial abort
Syntax:
AT**dabort=
Parameters:
0:
Dialling will not be aborted by incoming characters.
1: Characters from DTE aborts dial during the connection process (default).
**dbits – Asynchronous databits
Syntax:
AT**dbits=
AT**dbits=?
AT**dbits
Parameters:
:
7:
Set format to 7 databits
8: Set format to 8 databits
E – Echo
Syntax:
ATE
Parameters:
0:
Characters are not echoed
1: Characters are echoed