Wavetronix SmartSensor 105 (SS-105) - Quick-reference Guide (Installer) - Manual (Page 3)

6
Attach the pole-mount box
1 Attach the mounting brackets to the back of the pole-mount
box.
2 Thread the mounting straps throught the mounting brackets.
3 Position the pole-mount box onto the pole and attach the box to
the pole using the mounting straps.
4 Run the sensor and homerun cables through the cable grips on
the bottom of the pole-mount box.
7
Connect surge protection and power
1 Disconnect the Click! 200 from the
DIN rail.
2 Disconnect the green screw terminals
on the PROTECTED side (top) of
the Click! 200 and wire the sensor
cable as shown in the diagram.
3 Connect the Click! 200 to the DIN
rail.
4 Connect the ground terminal to the
DIN rail and the earth ground wire
to the lug bolt on the bottom of the
pole-mount box.
5 Connect the exterior lug bolt to earth
ground.
6 Connect 10–30 VDC to the +DC
and –DC terminals on the UNPRO-
TECTED side (bottom) of the Click!
200.
Note. If you have a homerun connection to
a main traffic cabinet, refer to Chapter 2 of
the SmartSensor User Guide.
From
SmartSensor
+DC GND GND GND
RTS CTS TD RD
Power Drain
RS-485 Drain
Black
Red
Blue
Orange
Brown
Yellow
Violet
RS-232 Drain
Gray
-485 +485 GND GND
From
Sensor
White