Wavetronix SmartSensor 105 (SS-105) - Quick-reference Guide (Installer) - Manual (Page 2)

4
Align the sensor to the roadway
1 Tilt the sensor down so that the front is aimed at the center of the detection area.
2 Adjust the side-to-side angle to within approximately 2° of perpendicular to the flow of traffic.
3 Tighten the mounting bracket bolts.
1 2 3 4 5 6 7 8
Tilt the sensor down towards the center of the traffic
Attach the mount bracket to the pole:
1 Insert the stainless steel straps through the slots in the mount
bracket.
2 Position the mount on the pole so that the head of the mount
is pointing towards the middle of the lanes of interest.
3 Tighten the strap screws.
Attach the sensor to the mount bracket:
1 Align the bolts on the back of the SmartSensor with the
holes on the mounting bracket. The large 25-pin connector on
the SmartSensor should be pointing towards the ground.
2 Place the lock washers onto the bolts after the bolts are in the mounting bracket holes.
3 Thread on the nuts and tighten.
3
Attach the sensor and mount bracket to the pole
5
Attach the 9-conductor cable
1 Tear the tab off the tube of silicon dielectric compound and squeeze
about 25% of the silicon into the connector at the base of the SmartSen-
sor. Wipe off any excess compound.
2 Insert the cable into the connector and twist clockwise until you hear it
click into place.
3 To avoid undue movement from wind, strap the cable to the pole or run
it through a conduit, but leave a small amount of slack at the top of the
cable to reduce strain.