Watson-Marlow FF30 V2 - Manual (Page 5)

INSTRUCTION HANDBOOK
FF30 V2
FF30 IH EN 74-216-201 v1.20.doc Page 5 of 26
1.4 Caution and employee safety
This manual should be read before using the FF30.
It is strongly advised that
- Any kind of maintenance or cleaning of the machine not is carried out while power is
connected
-
Unauthorised / non-trained personnel should not open the cover of the electrical parts
- The machine is placed in such a way that it is not exposed to high humidity, high temperatures
or other abnormal operating environment.
-
The machine is not to be used in explosion hazardous environments.
1.5 Essential training before daily use
Read the section with Daily Use, thoroughly before using the machine.
Protective equipment and protective devices are installed:
 If the star wheel is jammed it will stop immediately
 The capping machine will stop if it is unable to reach lower position during capping; e.g. this
way fingers or instruments will not be squeezed if they are placed between the cap and the
capping head during production.
Always respect the symbols on the machine.
Cleaning must be performed as described in this IH.
1.6 References
N/A
1.7 Dismantling and disposal
Prior to dismantling, it must be observed that all services are disconnected, and fixing to other
equipment is removed.
WM-Flexicon machines may not be disposed using normal refuse
collection. The machines must be collected and disposed separately as
they contain electrical components such as batteries, electrolyte
capacitors, liquid crystal displays and printed circuit boards.
Further information is available on
www.wmflexicon.dk .
*
* (WEEE) DS/EN 50419