Watson-Marlow FS32 - Manual (Page 11)

INSTRUCTION HANDBOOK
FS10, FS32
FS10-32 IH EN 74-215-021 v1.02.doc Version: 1.02 Page 11 of 17
3.3 Mounting of bottle tool
Place the bottle
tool on the
bracket and
mount the screw.
Note: If the bottle tool is mounted too close to the machine the switch function will not work, see
section 4.1
4 Adjustments
4.1 Adjustment of the height of the capping head
Before starting the production the initial height of the capping head and the bottle tool should both be
adjusted.
Begin with the bottle tool; for safety reasons switch the power OFF
Place a bottle on the base plate under the capping head.
Loosen the handle “B” and lower the capping head until it is just above the bottle neck.
Now adjust the bottle tool so the bottle is centred under the capping head – WHEN THE BOTTLE
TOOL IS PUSHED “IN”
Now FS10 is ready for height adjustment.
IN
OUT