Vir2 Instruments Acou6tics Manual User Manual

Page 35

ou6tics

HAP

tER 19

/ V

UME & D

YNAMIC

SETUP PER

STRING

FRET

Volume | Lowest String/Highest String:
Setup the volume for the lowest and the highest string here. The volume of

the strings in between is interpolated.
The x-axis of the table (from left to right) represent the frets of the each

string. The y-axis (from bottom to top) represents the volume amount in

percent.

Decay (MS) | Lowest String/Highest String:
Setup the sustain decay for the lowest and the highest string here. The

sustain decay of the strings in between are interpolated.
This setting affects how much build up is taking place when two or more

notes on the same string and fret are played shortly after each other. Lower

values mean less build up/overlay of two notes. Higher values mean more

build up/overlay of two notes.
The x-axis of the table (from left to right) represent the frets of the each

string. The y-axis (from bottom to top) represents the sustain decay in

milliseconds (1000ms = 1s).

Decrease Release Volume (MDB/S) | Lowest String/Highest String:
Setup how loud release samples are in relation to how long you held a note

for the lowest and highest string here. The decrease release volume value of

the strings in between are interpolated.
The x-axis of the table (from left to right) represent the frets of the each

string. The y-axis (from bottom to top) represents the decrease of the

release volume in mdB / s (1000 mdB = 1 dB). For example: If you set the

decrease release volume to 3000 mdB/S, this will mean that with each

second you hold a note, the release volume will be decreased by 3dB.

cHAPtER 19

cHAPtER 20

AcoU6tIcS V&D PER ARtIcULAtIoNS coNt’D

HAP

tER 20

/ L
EGA

AMPLE

AR
T

SETUP

PER
AR
TICULA

TION

STRING

&
FRET

Legato Sample Start Setup | Per Articulation, String & fret

This page switches the engine into a sample cutting mode. You can select
each legato articulation and setup a sample start for each fret. You can test
and cut each fret by playing a note in the play range marked with the blue
keys on Kontakt’s virtual keyboard. For example, E1 will play fret 0, F1 will
play fret 1, F#2 will play fret 2 and so on. To leave the sample cutting mode
simply close the advanced setup tab or switch back to page 1.

Note: We recommend not to change the default values. We spent a lot of
time setting them up correctly.

Acou

tics/Advanced Setup

Legato Sample Start Setup

Per Articulation, String & Fret