Vir2 Instruments Acou6tics Manual User Manual

Page 28

ou6tics

Acou

tics/Advanced Setup

PITCHBEND & VIBRATO

SETUP

Acou

tics/Advanced Setup

STRUMMING SETUP

HAP

tER 13

/ PIT

CHBEND &

VIBRA

TO SETUP

HAP

tER 14

STRUMMING

SETUP

Pitchbend | Range:

Change the pitch bend range here.

Vibrato | Mode:

Change the vibrato mode here.

• All Strings

• Last String | Note: Only works with chord detection = 0ms

• Highest String | Note: Only works with chord detection = 0ms

• Lowest String | Note: Only works with chord detection = 0ms

Vibrato | curve:

Change the vibrato curve here.

Vibrato | Max:

Change the maximum strange (?) of the vibrato here.

Vibrato Speed | Min/Max:

Set up the minimum and maximum rate of the vibrato here.

Vibrato | type:

There are 2 options for vibrato type: ‘

Up’ and ‘Up & Down’. On a real guitar

you can only bend upwards, not downwards. So the default setting here is
‘

Up’, which means that the vibrato is always slightly sharp compared to

traditional LFO vibrato.

Strum | Default:

Set up the default strum type for chords played on the keyboard here.

Strum time | Auto Adjust:

Strum time in Acou6tics means the time difference between one string and
the next in a strum. If ‘

Strum time’ is set to 10ms, a strum over all six strings

for example will take 60ms. ‘

Auto Adjust’ will automatically vary this strum

time. If a six string strum takes 60ms, a four string strum will also take
60ms, because the engine automatically compensates the strum time when
playing a four string strum. You can also set up the amount of ‘

Auto Adjust’

here. 100% means full adjustment, 10% for example, means that a four string
strum will only be slightly slower than a six string strum.

DoWN-StRoKE | UP-StRoKE

Strum Speed | Start:

Set up the strum speed at the beginning of a strum here. If you set it to
110% and you have a strum time of 100ms, the strum speed at the beginning
of the strum will be 110ms. The ‘

Strum Speed | Start’ and ‘Strum Speed |

End’ settings will allow you to accelerate or slow down a strum over time.

Strum Speed | End:

Set up the strum speed at the end of a strum here. If you set it to 90% and
you have a strum time of 100ms, the strum speed at the end of the strum
will be 90ms. The ‘

Strum Speed | Start’ and ‘Strum Speed | End’ settings

will allow you to accelerate or slow down a strum over time.

cHAPtER 13

cHAPtER 14