Upsite 10163 Modular Containment: Bi-Directional Doors - Manual (Page 2)

Installation Guide
2. Attach the AisleLok ® Bi-Directional Doors to the cabinets
a. Stand the LH AisleLok ® Bi-Directional Doors up vertically.
b. Note the (3) metal registration tabs located behind each of the hinge points.
c. Position the door against the cabinet side panel so that the metal tabs on
the back side of each hinge fit into the seam between the door and the front
edge of the cabinet frame. All (3) registration tabs should fit flush, contacting
the front edge of the cabinet frame.
d. While holding the door in position, starting with the middle hinge position,
turn each of the magnet twists counterclockwise until you encounter the
physical stop point; this will fully engage the magnet against the cabinet
side panel. Once both the middle magnets are fully engaged, the door will
support itself.
e. Before completing the engagement of the other (4) magnets, turn down the
bottom leveling foot making sure the door is positioned with a minimal gap
between the door and the floor (<1").
f. With the door properly positioned, turn the remaining top and then bottom
magnet twists counterclockwise until fully engaged. Confirm each of the
magnets are making full contact.
g. Repeat the same process for the RH door.
3. Position the Hanger Assembly on top of the cabinet
Attach the LH hanger assembly to so the magnet contacts the top of the
cabinet. This feature provides additional holding power to the door. Repeat for
the RH hanger assembly.
a. The magnet position on the hanger is adjustable. Out-of-the-box magnet
position should allow the hanger assembly to contact the top of the cabinet
sheet metal surface once installed.
b. Install the Hanger Assembly over the studs in the top hinge assembly.
c. Slide the assembly down until the magnet contacts the top of the cabinet.
d. Attach the LH hanger assembly using the supplied thumbscrews. If the magnet
does not make full contact, remove the hanger assembly and readjust.
e. Repeat for the RH hanger assembly.
Note: To Remove the AisleLok ® Bi-Directional Doors simply
reverse Steps 1 – 3
To prop open the doors
Open the door against the side panel and then drop down the door stop foot.
Instructions for Cleaning
a. To clean clear plastic panels, mix warm water with a small amount of liquid
household detergent.
b. Using a micro fiber towel, lightly apply mixture to the clear plastic. It is not
recommended to use abrasive cleaning items (i.e. scratch pads), as these
items have the potential to damage the product.
c. Wipe dry with a clean microfiber towel.
Registration
Tab
Magnet Twists
Leveling Foot (Bottom Hinge)
Hanger Assembly