Upsite 10033 Blanking Panel – 2U - Manual (Page 2)

2 Designer & Manufacturer
(888) 982-7800 www.upsite.com
Installation Guide
HotLok Blanking Panel
Product Specifications
Installation Procedures
Typical Installation Procedures
1. Using the finger grips to hold the HotLok Blanking Panel, align the four
pins with the holes in the side rail. Ensure the product is level and pins are
even on each side.
2. Guide one side of the blanking panel into the side rail. Once seated, push
the opposite side of panel into place until clips click firmly into place.
If panels are difficult to insert, see the Installation Procedures for Tight
Rails on page 4 of this guide.
3. The clips should be fully inserted and seated with the plastic edge flush
against the side rail. Depending on the size of the rack holes, the panel
may be able to slide up or down. This is a built in feature to add room for
the flared sealing vanes to create a tight seal. When you place multiple
panels they will move and self-seal.
4. To maintain the best seal possible, fill all open spaces so that blanking
panels push up against equipment.
5. Please note that the last blanking panel to be installed in a space might
require some additional force to squeeze into place due to the tight fit
produced by the flared vanes.
6. When uninstalling HotLok Blanking Panels, place one hand on the panels
above or below it and slowly pull out the first unit. The tight fit can some-
times pull out other panels unintentionally.
Dimensions Inches Millimeters
Part No. 10031 & 10114 - 1U - Overall size (length x height) 19” x 1.75” 482.5 x 44.45mm
Part No. 10033 & 10115 - 2U - Overall size (length x height) 19” x 3.5” 482.5 x 89mm