Tri Tool SQM-2AC Squaring Module - Manual (Page 8)

8
TRI TOOL INC.
92-0714 : Rev. 970428
WARNING:
MAINTENANCE
All components should be cleaned and coated with a light film of oil prior to use.
Use a clean, non-detergent oil, preferably SAE 10 (90 SSU) or lighter.
If the Model SQM-2AC is operated in such a manner that it collects debris while
cutting, it should be cleaned after each cutting operation.
Tool life may be severely shortened, unless chips and/or other debris that
have been deposited on the cutting head during the machining operation are
removed.
RECOMMENDED MAINTENANCE SCHEDULE
Daily maintenance when the unit is in operation include a visual inspection of loose
screws, missing screws, damage, etc.
Wipe the unit down and spray with rust preventative under severe humidity
conditions.
STORAGE
If the Model SQM-2AC is to be stored or if it will remain out of service for asignificant
period of time (30 days or more), it should be thoroughly cleaned, lubricated and
sprayed with a rust preventative prior to storage.