Tri Tool 75-0115 Air Caddy - Manual (Page 5)

5
92-0896 : Orig. 001215
Model 75-0115 Air Caddy
Remove adjusting keys and wrenches before applying power to the equipment. De-
velop a habit of checking the tool before turning it on to make sure that all keys and
wrenches have been removed.
Do not force tools. Tools and tool bits function better and safer when used at the feed
and speed rate for which they were designed.
Do not reach into rotating equipment. Do not reach into the rotating head stock to clear
chips, to make adjustments, or to check surface finish. A machine designed to cut steel
will not stop for a hand or an arm.
Handle chips with care. Chips have very sharp edges and are hot. Do not try to pull
chips apart with your hands; they are very tough.
Avoid unintentional starts. Do not carry or handle tools with your hand on the operating
switches or levers. Do not lay the tool down in a manner that will start the drive. Do not
allow the tool to flip around or move when adjusting or changing tool bits.
Store idle tools properly. Disconnect tools from the power source and store in a safe
place. Remove tool bits for safe handling of the tool.