Tri Tool 75-0115 Air Caddy - Manual (Page 14)

92-0896 : Orig. 001215
TRI TOOL INC.
14
NOTE:
NOTE:
CAUTION:
When the desired operating pressure is achieved, the operator may lock the
adjusting knob by pushing it down.
To adjust the lubricator oil flow rate, turn the precision oil adjustment knob on
the top of the lubricator unit.
The oil flow response time is slow.
Start the lubricator oil flow rate, close the precision oil adjustment screw no
more than finger tight and then back it off 1/4 turn.
This is to prevent damage to the needle or the valve seat inside of the lubricator.
Air
Flow
Air
Flow
Precision Oil
Adjustment Knob
Oil Fill
Setting the Lubricator flow
The precision oil adjustment knob will break if over tightened.
For required flow rates see chart the following page.
This adjustment should be made with the air motor attached and running.
Clockwise decreases the rate of oil flow.
Counterclockwise increases the rate of oil flow.
Once set, the Flow-Guide® variable orifice in the lubricator will maintain the
same ratio of oil to air flow regardless of any change in the air flow rate.