Tri Tool 602-5SBM Clamshell Air User Manual

Page 25

Model 602.5SBM, Low Profile Clamshell

92-0093 Rev. 131230

Mount the Tool Blocks and Tripper Block to the Clamshell.

Check the adjustment of the slides and mesh of the Tripper Pin with the Feed

sprocket.

Select the proper Clamping Pad Set.

Install the Clamping Pad Set into the Clamshell.

If using the Fixed Clamping Pad Set then install the Clamping Pad Set so that the

pipe lays on the Fixed Pads or vice versa.

Fixed Pads should be located 90 degrees from each other.

Tool Block Selection

Tool Block

Assy

Height from Centerline of the

cut to the Headstock Face

Tool Block Travel

08-0036

1.50"

38.1 mm

.63"

16.0 mm

08-0096

.51"

13.0 mm

.40"

10.2 mm