Warning – Tri Tool 602-5SBM Clamshell Air User Manual
Page 23

23
Model 602.5SBM, Low Profile Clamshell
92-0093 Rev. 131230
NOTE:
WARNING:
NOTE:
Approach of the Feed Pin to the Feed Sprocket
Check that the air supply filter/regulator/lubricator is installed and set properly.
Check for proper alignment of the Feed Sprockets. Refer to the picture “Approach of
the Feed Pin to the Feed Sprocket”.
Run the Headstock slowly with the Feed Pin ‘in’ to insure that the Sprocket is set
right. (Do not run at full speed during the first revolution.)
You will break the Feed Pin if the Feed Pin to Sprocket alignment is incorrect.
WARNING
DO NOT OVERIDE THE DEADMAN SWITCH
ON THIS UNIT. Locking down, obstructing, or
in any way defeating the deadman switch on
this unit may result in serious injury.
Deadman Switch Warning
Turn on the Air Motor to full speed by opening the Throttle control Valve.
The Air Motor working speed will be about one half of the no-load speed.
(Refer to “Cutting Speeds” for speed selection chart).
Engage the feed by pushing the Tripper Shaft in.
- 204B Cutting Head (9 pages)
- 204B Cutting Head (10 pages)
- 204B Cutting Head (9 pages)
- 212B Single Point Spring Hanger Assembly (8 pages)
- 204B Cutting Head (13 pages)
- 204B Cutting Head (36 pages)
- 204B Cutting Head (17 pages)
- 201BA Beveler (36 pages)
- 204B Elbow Mandrel (16 pages)
- 204B Beveler (45 pages)
- 204B Flange Facer (21 pages)
- 206B Elbow Mandrel (17 pages)
- 206B Flange Facer (22 pages)
- 206B Beveler (45 pages)
- 212B ID Tracking Module (17 pages)
- 206B Miter Mandrel (16 pages)
- 206B Sleeve Mandrel (13 pages)
- 208B Elbow Mandrel (20 pages)
- 208B ID Tracking Module (18 pages)
- 208B Miter Mandrel (20 pages)
- 208B Flange Facer (28 pages)
- 208B Sleeve Mandrel (15 pages)
- 212B Elbow Mandrel (16 pages)
- 214B Beveler Single Point Flange Facer (41 pages)
- 212B Flange Facer (22 pages)
- 212B Miter Mandrel (20 pages)
- 212B Single Point Hydraulic Motor Assembly (9 pages)
- 212B Single Point Flange Facer Miter Mandrel (28 pages)
- 212B Sleeve Mandrel (12 pages)
- 214B Elbow Mandrel (20 pages)
- 214B Flange Facer (23 pages)
- 214B ID Track Module (19 pages)
- 214B Miter Mandrel Head Kit (22 pages)
- 214B Sleeve Mandrel (13 pages)
- 236B ID Tracking Module (23 pages)
- 224B Miter Mandrel (27 pages)
- 224B Single Point (30 pages)
- 230B Beveler Flange Facer (16 pages)
- 230B ID Tracking Module (15 pages)
- 230B Lifting Frame (19 pages)
- 236B Miter Mandrel (25 pages)
- 301SP Tube Squaring (35 pages)
- 236B Single Point (32 pages)
- 302 Tube Squaring Micro Feed Assembly (11 pages)
- 302 Tube Squaring (31 pages)