Tri Tool 572AC Sever Machine - Manual (Page 19)

19
Model 572AC SEVERMASTER®
92-0660 : Rev. 080423
MAINTENANCE
DAILY DURING/AFTER USE
Wipe the unit down and spray with a rust preventative under severe humid conditions.
All components should be cleaned and coated with a light film of oil after use.
Use a clean, non-detergent oil, preferably SAE 10 (90 SSU) or lighter.
Visually inspect for loose screws, missing screws, damage, etc.
AFTER 20 HOURS OF OPERATION
lubricate the male and female tool holder slides.
AFTER 40 HOURS OF OPERATION
thoroughly clean and lubricate main gear, drive gear, male and female tool slides, and
tripper bracket assembly.
STORAGE
If the Model 572AC is to be stored or if it will remain out of service for a significant
period of time (30 days or more), it should be thoroughly cleaned lubricated and
sprayed with a rust preventative prior to storage.
TOOL HOLDER MAINTENANCE
Clean the slide rails, the tool holder, and the feed components.
Inspect these parts for damage and replace as required.
Lubricate and reassemble.
Adjust the adjustable slide rail to provide a firm, but not excessive pressure on the tool
holder.