Tri Tool 572AC Sever Machine - Manual (Page 12)

12
TRI TOOL INC.
92-0660 : Rev. 080423
Wipe the internal contact surface clean before inserting another Collet into the
main housing.
Insert the correct Collet into the main housing and then slide the pusher sleeve back into
the main housing and into contact with the Collet.
Rotate the hinge bracket back up and let the eyebolt drop back into the slot.
Rotate the check nut on the eyebolt to secure in the slot.
MACHINING INSTRUCTIONS
Turn the motor on to full speed by depressing the lever.
The motor should be set at the low speed setting for 1.00” (25.4 mm) to 2.00”
(50.8 mm) DIA tube or at the high speed setting for .25” (6.4 mm) to 1.00” (25.4
mm) DIA tube.
Engage the feed by pushing the tripper shaft in.
Machining
Handle
Tripper Shaft
Motor Lever
Monitor the cutting operation and apply cutting fluid as necessary.