Tri Tool 306 Tube Squaring - Manual (Page 12)

12
TRI TOOL INC.
92-0746 Rev. 130415
CAUTION:
Continue rotating the Feed Knob clockwise until the end of the pipe is completely
machined.
Be careful not to let the Tool Bit(s) cut into the Saddles or the Saddle.
Discontinue feed and allow the Cutting Head to rotate one to three revolutions to
improve the finish of the prep surface.
Rotate the Feed Knob counter-clockwise to separate the Cutting Head and the pipe.
Stop the tool rotation by releasing the Trigger Switch.
Rotate the Feed Knob counter-clockwise until the Cutting Head clears the tube or
pipe by at least 1/8” (3 mm) or more.
Loosen the Saddle by rotating Saddle Handle Assembly to release the pipe.