Tri Tool 306 Tube Squaring - Manual (Page 10)

10
TRI TOOL INC.
92-0746 Rev. 130415
CAUTION:
OPERATION
Select the Tool Bit(s) required to machine the end configuration desired.
When performing a tube squaring operation the Tool Bit may be placed in any one of
three Cutting Head slots.
When performing any separate machining operation such as facing, beveling or
counter-boring, the Tool Bit(s) may be installed in any one of three Cutting Head
slots.
When performing any multiple machining operation such as facing, beveling or
counterboring, the Tool Bit(s) should be installed with one in each slots.
The use of dull Tool Bits or Tool Bits not manufacture by TRI TOOL Inc. may
result in poor performance and may constitute abuse of this machine and
therefore voids the TRI TOOL Inc. factory warranty.
Insert the Tool Bit(s) into the slot(s) in the Cutting Head.
Saddle Handle
Assembly
.001"
Feed Indicator
Feed Handle
Speed Control
On/Off Switch